Differences

This shows you the differences between two versions of the page.

--- xnorit:public:summary:3dprinterenclosure [2024/11/06 11:39] – [Fan] timdv91
+++ xnorit:public:summary:3dprinterenclosure [2024/11/06 11:42] (current) – [LED and fan control] timdv91
@@ Line 33: / Line 33: @@
 A fan mount was designed and 3D printed, using FreeCad. Which could then connect to the airvent outlet. A 3300 RPM desktop PWM fan was added inbetween, in order to provide enough pressure given the long outlet pipe.
-The PWM fan is controlled by a custom designed PWM controller, which hooks into the XnorDuino systm. So the RPM is calculated based on the 3D printers nozzle temperature, which can be requested through the 3D printers API.
+The PWM fan is controlled by a custom designed PWM controller, which hooks into the XnorDuino system. So the RPM is calculated based on the 3D printers nozzle temperature, which can be requested through the 3D printers API.
 {{:xnorit:public:summary:3dprinterenclosure:ksnip_20241010-234645.png?420|}}
@@ Line 63: / Line 63: @@
 {{ :xnorit:public:summary:3dprinterenclosure:ksnip_20241010-235206.png?400|}}
-The box with the blue LED has an Raspberry-pi and [[xnorit:public:summary:xnorduino|XnorDuino Master]] inside it, which controles the XnorDuino bus. This Raspberry-Pi wil for example:
+The box with the blue LED has an Raspberry-pi and [[xnorit:public:summary:xnorduino|XnorDuino Master]] inside it, which controls the XnorDuino bus. This Raspberry-Pi wil for example:
   * Request the Prusa's 3D printers API for nozzle temperature, in order to adjust the PWM fan's RPM.
   * Request the Prusa's 3D printers API for printer status (printing, pauzed, ended), in order to adjust the LED lights intensity.
   * Receive API calls from the [[xnorit:public:summary:inwalltouchscreen|in-wall touchscreen]], to adjust my [[xnorit:public:summary:ledlightsceiling|ceiling lights]] configuration.