Differences

This shows you the differences between two versions of the page.

--- xnorit:public:summary:freezermonitoringsystem [2024/10/13 11:49] – timdv91
+++ xnorit:public:summary:freezermonitoringsystem [2024/10/13 15:31] (current) – [Freezer monitoring system] timdv91
@@ Line 1: / Line 1: @@
 ====== Freezer monitoring system ======
-{{ :xnorit:public:summary:frost:ksnip_20241013-133209.png?400|}}
+One of the first projects I did a couple years ago, was designing a custom freezer monitoring system. It's end purpose was monitoring -80°C freezer, but I tested them successfully in liquid nitrogen, down to -196°C.
-One of the first projects I did a couple years ago, was designing a custom freezer monitoring system. It's end purpose was monitoring -80°C freezer, but they where actually tested down to -196°C in liquid nitrogen.
+{{ :xnorit:public:summary:frost:ksnip_20241013-135153.png?400|}}
-The system communicates wirelessly with two gateways, by using a Zigbee mesh network between multiple nodes. Both gateways are operating 24/7, but the system does run perfectly fine on one gateway. The second gateway is purely redundant to reduce potential downtime.
+The system communicates wirelessly with two gateways, by using a Zigbee mesh network between multiple nodes. The system works perfectly fine on one gateway, meaning the second gateway is purely redundant to keep up-time as high as possible.
-\\
+Some of the collected live data is available at: [[https://grafana.xnorit.be/|https://grafana.xnorit.be/]]
-\\
-\\
-\\
-\\
-\\
-\\
 \\
 \\
@@ Line 31: / Line 25: @@
 Optionally it's also possible to connect the module to a freezers alert port, which is basically a relay that triggers whenever the Freezer itself detects an issue. This provides an early warning, even before the temperature inside the freezer rises to much.
+===== 3D printing: =====
+{{ :xnorit:public:summary:frost:ksnip_20241013-133209.png?400|}}
+As this system is utilized in a very busy environment, I decided to go with a combination of aluminium shell and 3D printed covers for the IO. On the bottom are two neodinium magnets with each a pull-force of 3.3 kg, to keep the module neatly against the freezer.
+\\
+\\
+\\
+\\
+\\
+\\
+\\
+\\
+\\
+\\
+\\
+\\
+\\
+\\
+\\
+\\
+\\
+\\
+\\
+===== Software and GUI =====
+{{ :xnorit:public:summary:frost:dashboard_full.png?400|}}
+I decided to use a mySQL database for data storage, combined with Grafana as GUI. I'm however in the process of merging all data in an Influx database for performance improvements.