xnorit:public:summary:rpizerocamera
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| xnorit:public:summary:rpizerocamera [2024/10/13 11:25] – timdv91 | xnorit:public:summary:rpizerocamera [2024/10/13 11:25] (current) – [3D printing] timdv91 | ||
|---|---|---|---|
| Line 24: | Line 24: | ||
| A custom 3D printed enclosure was designed in FreeCad. I designed the setup with a flowerpot mount, as can be seen in the image above. Note that the screws are also 3D printed, which is especially recommended when clamping them onto a glass flowerpot. | A custom 3D printed enclosure was designed in FreeCad. I designed the setup with a flowerpot mount, as can be seen in the image above. Note that the screws are also 3D printed, which is especially recommended when clamping them onto a glass flowerpot. | ||
| - | \\ | ||
| \\ | \\ | ||
| \\ | \\ | ||
xnorit/public/summary/rpizerocamera.1728818720.txt.gz · Last modified: by timdv91