You can visit the Grafana dashboard at https://grafana.xnorit.be
Select a panel to view in the “0K_FreezerMonitoring” folder, as shown in the image.

A panel named with 'Light' provides the user with a quick and simple to read overview, with the drawback that it only contains an limited amount of data and information.

Each monitored freezers is provided with a small indication of the current temperature. Beneath the temperature is a small chart visible. If a temperature is out of range (As seen for freezer T_209), both temperature and chart change color.

The default color setting is:

• temperature below -100 = Blue
• temperature in-between -100 and -60 = Green
• temperature in-between -60 and -50 = Orange
• temperature in-between -50 = Red

Below the temperatures there is a field visible containing “Freezer health”. If a freezer supports this function, the freezer health will detect interruptions in freezer operation (breakdown/failure/AC loss). Using the default settings, this detection happens within 1 minute. The shown percentage is a calculated average over the selected time-span inside Grafana, see <color #ed1c24>panel settings</color> for more information.

A panel named with 'Full' provides a more thorough overview of each recorded freezer data, with the drawback of lessened readability. At the left an 'alert overview' is visible, providing an direct overview on freezers with possible issues.

The charts contain following information:

• Freezer health (purple/pink)
• Room temperature (Orange) (Measured within the monitor enclosure resulting in a ~5°C increase in temperature).
• Freezer temperature (Blue)
• Mail alert threshold (Red)

If the freezer temperature is below the set threshold, and the freezer health is above 50%, the hearth above the chart will indicate a green color. If the freezer temperature is above the set threshold, and the freezer health is below 50%, the hearth above the chart will indicate a red color (and is broken). If the preset alert conditions are met, the alert mode will first go in 'pending' state. The pending state is tagged on the chart using an orange vertical line. if the 'pending' problem is not resolved after (by default) 5 minutes, the state evolves to an alert, this is when en email is send as warning. An alert is tagged on the chart using an red vertical line.

A panel named 'ALL' contains a 'Light' representation of all connected freezers at a given site.